Enabling or disabling URL scanning using the CLI

Use the CLI commands in this procedure to enable or disable URL scanning.

To enable URL scanning:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Enable the settings for URL scanning.

hostname (config) # email-analysis policy url-scan enable

Save your changes.
```
hostname (config) # write memory
```

Verify the status of URL scanning.

hostname (config) # show email-analysis policy
Email-Analysis Policy:
  Analyze URLs in body:         yes
  Analyze attachments:          yes
  Analyze email using YARA:     yes
  Email YARA Weight Cap:        30
  .....

The Analyze URLs in body: line displays yes when URL scanning is enabled.

To disable URL scanning:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Disable URL scanning.

hostname (config) # no email-analysis policy url-scan enable

Save your changes.
```
hostname (config) # write memory
```

Verify the status of URL scanning.

hostname (config) # show email-analysis policy
Email-Analysis Policy:
  Analyze URLs in body:         no
  Analyze attachments:          yes
  Analyze email using YARA:     yes
  Email YARA Weight Cap:        30
  .....

The Analyze URLS in body: line displays no when URL scanning is disabled.