Prerequisite: You must make sure the fail-open switch is fully powered off before you attempt to remove it from the chassis.
Follow the steps in this section to power off and remove the fail-open switch.
Power off the fail-open switch using the web interface or CLI command prompt.
If you are using the web interface, click the Rescue tab and check the Power Off checkbox in the System Restore section. To access the web interface, refer Access the fail-open switch web interface.
.jpg)
If you are using the CLI command prompt, type
power_offand press Enter. To access the CLI command prompt, refer 3. Configure fail-open switch parameters_Silicom.
When the fail-open switch is powered off, remove the captive screws and slide it out of the chassis.