Adding an entry to the SmartVision alerts whitelist using the CLI

If alerts are triggered by valid traffic, you can add a combination of conditions for whitelisting SmartVision alerts.

Prerequisites

Admin access to the SmartVision appliance.

To add a combination of conditions to the SmartVision alerts whitelist:

View the SmartVision configuration.

In this example, the list is empty.

hostname # show smartvision alert whitelist

SmartVision Alert Whitelist Config
					
Rule        Source Prefix         Dest Prefix           Type

Add a combination of conditions to the SmartVision alerts whitelist by using the smartvision alert whitelist command.
This example adds a SmartVision alerts whitelist entry that combines a SmartVision rule ID and an IPv4 source address block:
```
hostname (config) # smartvision alert whitelist rule 91500002 source 192.168.4.0/24
```

Verify the change.

hostname (config) # show smartvision alert whitelist

SmartVision Alert Whitelist Config
					
Rule        Source Prefix         Dest Prefix           Type
91500002    192.168.4.0/24        -                     rule-source

Save your changes.
```
hostname (config) #  write memory
```