Deleting an entry from the SmartVision alerts whitelist using the CLI

If alerts are triggered by valid traffic, you can add a combination of conditions for whitelisting SmartVision alerts.

Prerequisites

Admin access to the SmartVision appliance.

To remove a combination of conditions from the alerts whitelist:

View the alerts whitelist.

In this example, the list contains a single entry that combines a SmartVision rule ID and an IPv4 source address block.

hostname (config) # show smartvision alert whitelist

SmartVision Alert Whitelist Config
					
Rule        Source Prefix         Dest Prefix           Type
91500002    192.168.4.0/24        -                     rule-source

Remove a combination of conditions to the alerts whitelist by using the no smartvision alert whitelist command.
This example removes the entry from the SmartVision alerts whitelist:
```
hostname (config) # no smartvision alert whitelist rule 91500002 source 192.168.4.0/24
```

Verify the change.

hostname # show smartvision alert whitelist

SmartVision Alert Whitelist Config
					
Rule        Source Prefix         Dest Prefix           Type

Save your changes.
```
hostname (config) #  write memory
```