The new docs.trellix.com features a modernized UI and AI-powered conversational search. Content is currently available in English, with additional languages launching in early November 2026. We hope you enjoy the updated experience.

Press CTRL+K to open search

Configure 100G Active Fail-Open chassis parameters

  • Published on Sep 17, 2026
  • 1 minute(s) read
Prev Next

You can access the command line interface through the console port (serial terminal emulator) and web-based management via a secure HTTPS connection on the management port (SSH remote shell emulator).

Steps:

  1. Ensure that the chassis power is turned on.

  2. Using an RJ45 RS232 console cable, connect a PC that is running the HyperTerminal to the Active Fail-Open Kit chassis.

  3. Launch the HyperTerminal and set the following communication parameters.

    • Baud rate: 115200

    • Data bits: 8

    • Parity: None

    • Stop bits: 1

    • Flow Control: XON/XOFF

  4. Click OK. The CLI banner and login prompt are displayed.

    Note

    The default Username and Password are Trellix00. The password is configurable.

  5. Type the following:

    1. Enable

    2. Configure

    3. management eth-if ip x.x.x.x

    4. management eth-if ip-mask y.y.y.y

    5. management eth-if default-gateway z.z.z.z

    6. write memory

      Note

      Reboot of the system is not required.

  6. To view the current network settings, use the following command:

    show management configured

    Sample output:

    IS100G_AFO> show management configured

    Interface Configurations:

    MacAddr : 00:e0:ed:93:24:9f

    Port : up

    IPOrigin : static

    IPAddress : 10.41.83.134

    IPMask : 255.255.255.0

    Default-Gateway : 10.41.83.252

    DHCPSendName : on

Copyright © 2026 Musarubra US LLC | Privacy | Legal | AI Disclaimer