The HelixConnect client is automatically enabled on appliances after Helix Enterprise mode is enabled on them. Use the commands in this section to enable or disable HelixConnect.
To enable HelixConnect client:
Go to CLI configuration mode:
hostname > enable hostname # configure terminalEnable the HelixConnect client:
hostname (config) # helixconnect enableVerify your change:
hostname (config) # show helixconnect
Important
Do not disable HelixConnect or unsubscribe the device unless you are advised to do so by Trellix Technical Support.
To disable HelixConnect client:
Go to CLI configuration mode:
hostname > enable hostname # configure terminalDisable the HelixConnect client:
hostname (config) # no helixconnect enableVerify your change:
hostname (config) # show helixconnect