Prerequisite: To enable proxy based outbound SSL/TLS decryption, you must purchase the System license and add it in the Manager. The System license required for proxy based SSL/TLS decryption is the same for both inbound and outbound.
To enable proxy based outbound SSL/TLS decryption, perform the following steps:
Go to Devices → <Admin Domain Name> → Devices → <Device Name> → Setup → TLS Decryption.
On the Outbound tab, select Decryption Settings tab.
.png?sv=2026-02-06&spr=https&st=2026-11-20T08%3A36%3A08Z&se=2026-11-20T08%3A47%3A08Z&sr=c&sp=r&sig=7p9mlpim5cT0lSJty9i66yECIe2yNgAhDekGgg5TSiw%3D)
Deselect Inherit Settings to override the settings of the parent domain.
Select the Enable Outbound Decryption checkbox.
Select the required action from the Untrusted/Expired Server Certificate drop-down.
The reasons for failure can be due the Sensor not being able to validate the web server's certificate. This happens when the certificate signed by a CA is not on the Sensor's trusted CA list.
The descriptions for the possible Sensor actions in case of a failure are as follows:
Action
Description
Decrypt
The Sensor decrypts the flows from the web server.
Block Flow
The Sensor blocks the flows from the web server.
Click Save.
Note
If a System license is not assigned to a Sensor, a warning The device requires a valid System license is displayed in the Deploy Pending Changes page for that particular Sensor. To assign a valid license, see section Add a System license to the Manager.
If you change the mode of operation for SSL/TLS decryption, or disable SSL/TLS decryption, a reboot of the Sensor is required.
Note
Reboot of the Sensor is required after you enable outbound SSL/TLS decryption for the feature to function. If you have already configured proxy based inbound SSL/TLS decryption, the reboot is not required.
Go to, Manager → <Admin Domain Name> → Troubleshooting → Logs → Faults.
View the critical messages for the corresponding Sensor to see if a Sensor reboot is required.
If yes, perform a full reboot of the Sensor.