The new docs.trellix.com features a modernized UI and AI-powered conversational search. Content is currently available in English, with additional languages expected in November 2026. We hope you enjoy the updated experience.

Configuring proxy based outbound SSL/TLS decryption at the domain level

Prev Next

Prerequisite: To enable proxy based outbound SSL/TLS decryption, you must purchase the System license and add it in the Manager. The System license required for proxy based SSL/TLS decryption is the same for both inbound and outbound.

To enable proxy based outbound SSL/TLS decryption, perform the following steps:

Note

From 11.1.5.122, jumbo frame traffic with SSL/TLS encryption will be decrypted when SSL/TLS decryption is enabled.

  1. Go to Devices → <Admin Domain Name> → Global → IPS Device Settings → TLS Decryption.

  2. On the Outbound tab, select Decryption Settings tab.

  3. Select the Enable Outbound Decryption checkbox.

    Outbound_DomainLevel.png
  4. Select the required action from the Untrusted/Expired Server Certificate drop-down.

    The reasons for failure can be due to the Sensor not being able to validate the web server's certificate. This happens when the certificate signed by a CA is not on the Sensor's trusted CA list.

    The descriptions for the possible Sensor actions in case of a failure are as follows:

    Action

    Description

    Decrypt

    The Sensor decrypts the flows from the web server.

    Block Flow

    The Sensor blocks the flows from the web server.

  5. Click Save.

    Note

    If a valid System license is not assigned to a Sensor, a warning The device requires a valid System license is displayed in the Deploy Pending Changes page for that particular Sensor. To assign a valid license, see section Add a System license to the Manager.

  6. If you change the mode of operation for SSL/TLS decryption, or disable SSL/TLS decryption, a reboot of the Sensor is required.

    Note

    Reboot of the Sensor is required after you enable outbound SSL/TLS decryption for the feature to function. If you have already configured proxy based inbound SSL/TLS decryption, reboot is not required.

    1. Go to, Manager → <Admin Domain Name> → Troubleshooting → Logs → Faults.

    2. View the critical messages for the corresponding Sensor to see if a Sensor reboot is required.

    3. If yes, perform a full reboot of the Sensor.