Enabling and disabling context service using the CLI

Follow these steps to enable or disable context service.

Prerequisites

Admin access to the SmartVision appliance.

To enable or disable context service:

Log in to the appliance CLI and go to configuration mode:
```
hostname > enable
hostname # configure terminal
```
Enable or disable the context service.
To enable the service, use the smartvision context-svc enable command:
```
hostname (config) # smartvision context-svc enable
Enabling SmartVision.
```
To disable the service, use the no form of the command:
```
hostname (config) # no smartvision context-svc enable
Enabling SmartVision.
```

Verify your configuration change.

In the following example, both and the context service are enabled.

hostname (config) # show smartvision status
SmartVision State
        Detection                      : yes
        Context Service                : running
        .
        .
        .

hostname (config) # show smartvision config

SmartVision Config

        Detection Enabled             : yes
        Context service enabled       : yes
        .
        .
        .

Save your changes.
```
hostname (config) #  write memory
```