Viewing the context service status using the CLI

Enable or disable the context service.

1. To enable the service, use the smartvision context-svc enable command:

   hostname (config) # smartvision context-svc enable
   Enabling SmartVision.

2. To disable the service, use the no form of the command:

   hostname (config) # no smartvision context-svc enable
   Enabling SmartVision.

Verify your configuration change.

In the following example, both and the context service are enabled.

hostname (config) # show smartvision status
SmartVision State
        Detection                      : yes
        Context Service                : running
        .
        .
        .

hostname (config) # show smartvision config

SmartVision Config

        Detection Enabled             : yes
        Context service enabled       : yes
        .
        .
        .