Follow these steps to enable or disable blocked-by-proxy detection using the CLI. The feature is disabled by default.
Prerequisites
Admin access to the Network Security appliance CLI.
To enable or disable blocked-by-proxy detection:
Go to CLI configuration mode.
hostname > enable hostname # configure terminal
To enable blocked-by-proxy detection, use the following command:
hostname (config) # swg scan block-by-proxy enable
To disable blocked-by-proxy detection, use the “no” form of the command:
hostname (config) # no swg scan block-by-proxy enable
Verify your changes.
hostname (config) # show swg config hostname (config) # show fenotify preferences bbo
Save your changes.
hostname (config) # write memory