Follow these steps to enable or disable custom rules on the appliance or sensor using the CLI.
To enable custom rules:
Enable the CLI configuration mode.
hostname > enable
hostname # configure terminal
Enable custom rules.
hostname (config) # fenet security-content custom rule enable
Verify the status for custom rules.
hostname (config) # show fenet security-content custom-rule Custom Rules: Enabled : yes
Save your changes.
hostname (config) # write memory
Saving configuration file ... Done!
To disable custom rules:
Enable the CLI configuration mode.
hostname > enable
hostname # configure terminal
Disable custom rules.
hostname (config) # no fenet security-content custom rule enable
Verify the status for custom rules.
hostname (config) # show fenet security-content custom-rule
Custom Rules:
Enabled : no