Enabling or disabling the Communications Broker Sender using the CLI

Use the CLI commands to enable or disable the Communications Broker Sender.

To enable the Communications Broker Sender:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Enable the Comm Broker on the appliance.
```
hostname (config) # commbroker enable
```
If the Comm Broker is enabled to receive and send third-party logs to Helix Enterprise on the Network Security appliance, the following message appears:
Enabling commbroker

Verify the status of the Comm Broker.

hostname (config) # show commbroker status
Commbroker status
        State:    Enable
        Running Status:    Running
        Platform support:    Supported

To disable Communications Broker Sender:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Disable the Comm Broker on the appliance.
```
hostname (config) # no commbroker enable
```
If the Comm Broker is disabled, the following message appears:
```
Disabling commbroker
```

Verify the status of the Comm Broker.

hostname (config) # show commbroker status
Commbroker status
        State:    Disable
        Running Status:    Not Running
        Platform support:    Supported