High-level configuration steps

Prev Next

The high-level configuration steps to inspect VM traffic are as follows:

  1. Install the Manager and Sensor running on 8.1 or later. See the Trellix Intrusion Prevention System Installation Guide for details. Make sure the Manager and Sensor are functioning correctly.
  2. Identify the Sensor monitoring port that you want to use for inspecting VM traffic. Deploy this port in the SPAN mode. This port must not have any subinterfaces configured. Refer to Configuration of monitoring ports, for information on how to configure a monitoring port in SPAN mode.
  3. Review the policies selected in the Policy Manager page for the SPAN port mentioned above. Note that the Sensor will apply these on the VM traffic. Refer to Assign IPS policies to interfaces and subinterfaces, for information.
  4. Make sure all the required VMware and Reflex applications are installed and functioning properly.
  5. Configure the port-mirroring feature on the vSphere Distributed Switch (VDS). All the traffic from the VMs that you want to monitor are mirrored to another virtual port. This is the destination port in the port-mirror. Information on how to configure port-mirroring is provided a subsequent section. Also, refer to the vSphere Networking Guide.

    If the destination port in the port-mirror is connected to a physical switch, then the Sensor's SPAN port must be connected to a SPAN port on that physical switch. This is discussed in the subsequent sections.

  6. The following sub-steps are applicable only if you are using VMware applications:
    1. Create a security group named TrellixQuarantine Group in the vShield Manager. This is required to quarantine VMs.
    2. Install vShield App on all the ESX servers in the datacenter. This ensures that a quarantined host continues to be in quarantine even if it is moved to a different ESX server.
    3. Configure the L3 and L2 access rules for TrellixQuarantine Group that drops all traffic.
    4. In the Manager, configure the Sensor SPAN port as a VM-Aware port and configure the vCenter and vShield details.
    5. View the VMware details in the corresponding alerts and quarantine the hosts as required.
  7. The following sub-steps are applicable only if you are using Reflex applications:
    1. Create the security policy named TrellixQuarantine on the VMC server.
    2. Configure the IDS Redirector on the VMC server.
    3. On the VMC server, enable the TrellixQuarantine policy.
    4. Enable the required APIs on the VMC server for the Manager to integrate with the VMC server.
    5. In the Manager, configure the Sensor SPAN port as a VM-Aware port and configure the vCenter and vShield details.
    6. View the VMware details in the corresponding alerts and quarantine the hosts as required.