Quarantining virtual machines using third-party applications

Prev Next

A virtual data center typically consists of a cluster of VMware ESX servers. Each ESX server hosts multiple VMware Virtual Machines (VMs). The network traffic flowing between VMs, especially between the VMs on the same physical ESX server, poses a blind spot to IPS appliances, thus evading detection. By redirecting a copy of the traffic to a Sensor, attacks in the VM traffic can be detected using Trellix IPS.

You can configure Trellix IPS to inspect:

  • Traffic originating from a VM and destined to go through the physical network.
  • Traffic destined to a VM on a different ESX server within the same data center.
  • Traffic destined to a VM within the same ESX server.

For a Sensor to inspect the traffic from VMs, you must deploy a monitoring port in SPAN mode. Tap and inline modes are not supported for VM traffic. The Sensor inspects the traffic from the VMs against the IPS and Recon policies that you specified for that port. As in the case of normal traffic, it raises an alert when it detects an attack. From the Attack Log, you can quarantine that VM. The attacking VM is then placed in a quarantine zone, which limits or turns off all further network communication. Any other response action applicable to SPAN mode is also possible. However, note that just like in the case of normal traffic inspection in SPAN mode, the attack might have reached the destination. That is, only IDS is possible and not IPS.

There are two methods by which VM traffic can be inspected and the attacking VM quarantined:

  • Method 1: You integrate the Manager with VMware vCenter and VMware vShield. This allows for flexible quarantine zone creation.
  • Method 2: You integrate the Manager with Reflex Virtualization Management Center (VMC) and Reflex vTrust.

In both the methods you must configure the monitoring port in SPAN mode. This enables you to choose the interface type VM-Aware in the Manager. A VM-Aware port can only be a dedicated interface in SPAN mode. That is, it cannot have subinterfaces.