This command resets all configuration values to their defaults. It deletes or resets values as described in the following table. This command causes an automatic reboot of the Sensor. You must confirm that you want to reboot the Sensor.
| Deleted Values
|
Values Reset to Defaults
|
- Manager address (and secondary interface's IP address, if configured). This can be IPv4 or IPv6 address.
- Certificates establishing trust between Sensor and Manager (shared key value)
- Signatures
- TFTP server IP address (IPv4 or IPv6 address)
- SCP server IP address (IPv4 or IPv6 address)
- DoS profile files (learned DoS behavior)
- SSL Key
- Exception Object
- ACL
- Advanced Setting
|
- Monitoring and Response port settings
- Management port settings
- Manager Install port value
- Manager Alert port value
- Manager Log port value
|
This command has no parameters.
Syntax:
resetconfig
Applicable to:
NS-Series Sensors