This command configures the settings for Layer 2 mode on drops.
Syntax:set l2OnDrops (enable|disable|sensitivity-level)
| Parameter | Description |
|---|---|
| enable | Puts the Sensor to Layer 2 mode when high drops are seen |
| disable | Disables Layer 2 mode on drops |
| sensitivity-level | Configures the sensitivity level for Layer 2 mode on drops |
intruShell@john> set l2OnDrops enable
intruShell@john> show l2OnDropsConfig
L2OnDrops Stats: Enabled
Note
To view the status of set l2OnDrops, provide show l2OnDropsConfig command.
NS-series Sensors
Note
- The Layer 2 mode must be 'ON' to configure set l2OnDrops (enable|disable|sensitivity-level).
- To automatically restore the Sensor to normal state, configure latency-monitor restore-inline command. For more information, refer to latency-monitor restore-inline.
- For more information on set l2OnDrops sensitivity-level command, refer to set l2OnDrops sensitivity-level.
- For more information on show l2OnDropsConfig command, refer to show l2OnDropsConfig.