You can set the Sensor's IPv6 address and subnet mask using this command.
Syntax:
set sensor ipv6 <A:B:C:D:E:F:G:H/I>
Parameter | Description |
|---|---|
<A:B:C:D E:F:G.H/I> | Indicates a 64-bit address written as octet (eight groups) of four hexadecimal numbers, separated by colons. Each group (A,B,C,D, etc.) represents a group of hexadecimal numbers between 0000-FFFF. This is followed by a prefix length I with value between 0 and 128. |
Example:
set sensor ipv6 2001:0db8:8a2e:0000:0000:0000:0000:0111/64
Note
If one or more four-digit group(s) is 0000, the zeros may be omitted and replaced with two colons (::). For example:
set sensor ipv6 2001:0db8:8a2e::0111/64
Applicable to:
NS-series Sensors