This command is used to set the operational mode of NS9600/NS9500 Sensors. This command takes the following parameters:
Important
Only NS9600 Sensors can be configured as Suricata Sensors.
Parameter | Description |
|---|---|
| The Sensor works as part of a stack. |
| The Sensor works as a standalone. |
| The Sensor works as Suricata standalone. |
| The Sensor works as part of the Suricata stack. |
Syntax:
set sensor mode <stack | standalone | suricata | suricata-stack>
Applicable to:
NS9600 (IPS stack, IPS standalone, Suricata standalone, and Suricata stack) and NS9500 (IPS stack and IPS standalone) Sensors only