Set two port link threshold

When a link failure occurs on Net0 or Net1, its peer port (Net1 or Net0, respectively) is brought down automatically, if the set threshold time is exceeded.

For example, if a threshold of 5 seconds is set and a link failure occurs on Net0, Net1 is brought down automatically when the failure lasts for more than 5 seconds.

Note
if the port recovers before the set threshold time, its peer port is not brought down.

Refer to the following steps to set the two port link threshold:

Steps:

Open an ssh session to login to the 100G Active Fail-Open.
At the login prompt, enter the default username Trellix00 and password Trellix00.
Type the following:
1. IS100G_AFO> enable
2. IS100G_AFO# configure
3. IS100G_AFO(config)# afo segment <1.1/2.1> port two-ports-link-threshold <4-25 sec>
4. IS100G_AFO(config)# write memory
Note
The default threshold value is 4 sec.
To view the AFO configurations, execute the following command:
show afo configured
Sample Output:
IS100G_AFO(config)# show afo configured
Segment 1.1 Configuration:
ActiveOpMode : inline
HbModeActive : on
HbActiveRestore : on
HbInterval(ms) : 3
HbHoldTimer(ms) : 10
HbRecoverTimer(ms) : 0
HbActiveExpOpMode : bypass
DevPowerOffBypass : on
TwoPortLink : off
TwoPortLinkThreshold(sec) : 4
LinkSpeed : 100G
DefaultVLAN : 1