Setting the Sensor throughput threshold for specific devices

Select Devices → <Admin Domain Name> → Devices → <Device Name> → Setup → Performance Monitoring → Thresholds.

Thresholds sub-tab

Select Device Throughput Usage in the drop down list against Metric.

Enter the required threshold percentage in the Threshold [%] column (this value should be higher than the value in the Reset Threshold [%] column).

Select Generate Fault? generate fault.

Click Save.

Note

Click Defaults to set the threshold settings to the default values. Under Usage in the context of the throughput usage threshold is a 'falling threshold'. A fault is generated when the throughput % drops below a certain value. This is helpful on very busy networks, where a certain amount of traffic is always expected to be seen. This type of fault is a good indication that there is a communication problem on the network.