The show mgmtport command displays all the current configuration settings for the Sensor Management port.
This command has no parameters.
Syntax:
show mgmtport
Information displayed by the show mgmtport command includes the following:
The Sensor's Management port value (10000Mbps, 1000Mbps, 100Mbps, or auto-negotiate)
The Sensor's Management port link status (what speed the two devices settled upon—typically the highest common setting)
What mode has been settled upon
The link status
The capabilities of the Management port (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
What the Management port is advertising its capabilities as (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
The characteristics of its link partner (possible values are: 10000baseTx-FD, 1000baseTx-FD, 100baseTx-FD, 100baseTx-HD)
Sample Output:
For Sensor, the output is as shown below:
intruShell@john> show mgmtport
MGMT Ethernet port : auto negotiated
Settings for MGMT port :
Supported link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised link modes: 100baseT/Full
1000baseT/Full
10000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
Link detected: yes
eth0 Link encap:Ethernet HWaddr 00:1E:67:BB:B3:B1
inet addr:10.208.15.91 Bcast:0.0.0.0 Mask:255.255.255.0
inet6 addr: fe80::21e:67ff:febb:b3b1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:13164765 errors:0 dropped:1216912 overruns:0 frame:0
TX packets:1886946 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7487476603 (7140.6 Mb) TX bytes:175263884 (167.1 Mb)
Applicable to:
NS-series Sensors